FURTHER PRODUCT INFORMATION
MIX PROPORTIONS:
Dry mixture of glue mortar pour into about 5-6 litres of water and mix it (manually or automatically) until You get a homogeneous mixture. The glue is ready to use after 5 minutes and after mixing again. The glue mortar should be used up within 2-3 hours.
WORK:
The temperature of work should be from +5°C to +25°C. The ground, on which DLX K-15 is used should be dry, clean, fat-free and free of any other alien materials. Very absorbent ground should be stained with ACRYLIC GROUND STRONGER AG-015. If the ground is difficult, unstable, there should be adhesion try made. DLX K-15 should be put onto foamed polystyrene with the trowel, circulate the mortar on the whole surface of the board or use the edge-point method. Directly after putting the glue, put the board to the ground and bang it until it gets the desired form. Choose the amount of mortar so that 60 % of the board is sticked. When the mortar is dried, attach foamed polystyrene boards with the plastic connectors. The reinforced layer is made by stringing the DLX K-15 mortar onto isolation layer and to lute the glas fibre net in vertical lanes.
USE UP NORM:
Sticking polystyrene boards depending on the ground is 3,3 – 5 kg/m2
Making the reinforced layer is 3 – 3,5 kg/m2.
DIRECTIONS:
The guidelines describe the range of product’s use and advisable method of using it but it cannot replace a professional preparation for the work. The producer guarantees the product quality, but it has no influence on the conditions and method of using it.
ATTENTION:
The mortar contains cement. It gives alcaline reaction with water. Protect eyes and skin. If the product gets to eyes, wash them with water and contact a doctor.
SAFE KEEPING:
Store the product in the original packages in a dry room on pallets. Protect the product from moisture.
SHELF LIFE:
12 months from the production date stated on the package.
PACKAGING:
25 kg bags, 48 bags palette, 1200 kg.
TECHNICAL PARAMETERS
| Ingredients |
Portland cement, mineral fillers, modifiers |
| Mixture proportions |
0.20-0.24 L of water per 1 kg of the mortar
5.0-6.0 L of water per 25 kg of the mortar |
| Pre-ageing time |
5 min |
| Mortar workability time |
about 2-3 hrs |
| Application temperature |
from +5°C to +25°C |
| Adhesion to concrete |
air-dried
≥ 0.25 MPa |
| after 2 day immersion in water and 2 hour drying
≥ 0.08 MPa |
| after 2 day immersion in water and 7 day drying
≥ 0.25 MPa |
| Adhesion to EPS |
air-dried
≥ 0.08 MPa |
| after 2 day immersion in water and 2 hour drying
≥ 0.03 MPa |
| after 2 day immersion in water and 7 day drying
≥ 0.08 MPa |
| Content of soluble chromium VI in a ready to use mix |
≤ 0.0002% |
| Consumption |
|
| EPS picking |
3.3-5.0 kg/m2 |
| Installation of reinforced layer |
3.0-3.5 kg/m2 |
| Technical specification |
ETA 15/0311 dated 29/05/2015 |
Reviews
There are no reviews yet.